ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
November 24, 2017, 11:38:48 PM
Home Help Search Login Register
News: Please read the Forum Code of Conduct   >>Click Here <<
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  On30
| | |-+  ON30 Dcc sound on board 2-8-0 and shay
« previous next »
Pages: [1] Print
Author Topic: ON30 Dcc sound on board 2-8-0 and shay  (Read 2904 times)
george ferries

View Profile
« on: February 02, 2007, 02:40:29 PM »

I have two DCC sound on board engines, a 2-8-0 and the shay with Tsunami sound factory added.  I am unable to reprogram one of the engines to a diffeent address other than 3.  I have gone through the directions from Soundtraxx and MRC whose Express DCC system I have and have not been able to get anything to work.  I hope that someone can help.   Thank you.

George
Logged
Tim
Guest
« Reply #1 on: February 02, 2007, 03:02:03 PM »

George

According to the "Express" manual,  you cannot use adress programming
you have to do it  by using the CV programming method.

In the manual they mention "QSI" but the "Tsunami" presents the same
problem as "QSI".

Tim
Souderton, Pa
Logged
David

View Profile
« Reply #2 on: February 03, 2007, 04:15:13 PM »

In order to program a Tsunami DCC decoder you MUST have a DCC booster in series with your programming track leads. See Tony's trains web site for more information.

Regards,
David
Logged

Regards,
David Silverton
Vernon Hills, IL
K8UOP
Hoople

I like BIG steam.


View Profile
« Reply #3 on: February 03, 2007, 08:40:04 PM »

In order to program a Tsunami DCC decoder you MUST have a DCC booster in series with your programming track leads. See Tony's trains web site for more information.

Regards,
David

Or just program on the main.
Logged

-Hoople-

Modeling UP, SP, and D&RGW in colorado between 1930 and 1960.

GIVE US HARRIMAN STEAMERS BACHMANN!
ebtbob


View Profile WWW
« Reply #4 on: February 11, 2007, 08:15:58 AM »

Good Morning All,

        Someone correct me if I am wrong,  but I do not believe you can program and address on the main with ops mode programing.   All other CVs you can.

Bob Rule, Jr.
Hatboro, Pa.
Logged

Bob Rule, Jr.
Hatboro, Pa
In God We Trust
Not so much in Congress
GATSME MRRC - www.gatsme.org
Steve Magee

View Profile
« Reply #5 on: February 11, 2007, 07:34:15 PM »

Bob - not sure with other systems, but you can diefinitely program both short and long addresses on the main with the NCE PowerPro system.

Regards

Steve
Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!