ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
November 21, 2017, 12:28:59 AM
Home Help Search Login Register
News: Please read the Forum Code of Conduct   >>Click Here <<
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  E-Z App
| | |-+  E-Z App DC Mode Compatibility
« previous next »
Pages: [1] Print
Author Topic: E-Z App DC Mode Compatibility  (Read 8512 times)
airferber

View Profile
« on: April 13, 2016, 07:23:01 PM »

I have an EZ-App engine  Enabling DC mode works well with the Bachmann Controller #44212 after cycling the direction a few times.  Then I tried it with an MRC Tech 2-1400 Power Pack and a Kato Power Pack.  The DC-Mode didn't Enable itself.  If it was enabled with the Bachmann Controller,  It would only Run Backwards in DC mode on the MRC and Kato DC controllers.  It ran both directions off the bachmann controller just fine.  Hopefully a firmware update will improve compatibility with other DC controllers.  By the way, the firmware was updated before testing.

Just wanted to point that out there for Bachmann and Bluerail Trains to make a note of.

-Aaron
Logged
Grapevine Flyer

View Profile
« Reply #1 on: April 17, 2016, 05:31:53 PM »

Are you using "pulsed" power supplies?  I know the user guide states it won't necessarily work with pulsed power transformers.
Logged
airferber

View Profile
« Reply #2 on: April 18, 2016, 04:22:22 PM »

There is no pulse switch on the controller but when initially starting up, There is a slight pulse hum to the motor on any DC engine. so it may have some pulse involved at low voltage. but it is not PWM i think.  Every 0-16 Volt controller i have that has a little more power than the bachmann controller does have a little pulse hum when starting up at first.  The pulsed startup is for slow-speed OPs on DC Locos.

http://www.scottpages.net/ReviewOfControllers.html

(Look for the Tech 4 which i have)

Until the board can handle MRC Tech 2, 4 & 7 series in DC Mode,  I will just run them off the Bachmann 44212 controller if i use DC mode, and use the other controllers when in BLUETOOTH mode which is fine for now.

-Aaron
« Last Edit: April 18, 2016, 04:35:39 PM by airferber » Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!