ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
November 24, 2017, 12:31:59 PM
Home Help Search Login Register
News: Check out the photo gallery link above or >click here< to see photos of recently announced products!
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  Large
| | |-+  Climax DCC number changing
« previous next »
Pages: [1] Print
Author Topic: Climax DCC number changing  (Read 402 times)
winnetou

View Profile
« on: September 11, 2017, 09:36:19 AM »

Hello, I want to change the DCC-number from my Climax(Large) from 3 to 7. The Climax has soundtraxx-sound.But I have no sucess. I run with Digitrax and have also a computer for programming.Have anyone a solution for me?
Logged
Hunt
?
MBB


View Profile
« Reply #1 on: September 11, 2017, 12:54:20 PM »

Addressing Restriction

When using Ops Mode Programming   --- the SoundTraxx decoder does not allow changing the type of address currently in use. In other words, the decoder will ignore a change from a 2 digit address to another 2 digit address or from a 4 digit address to another 4 digit address.

Following is the workaround to the decoderís address type restriction when using Ops Mode Programming

If you can run the locomotive using 2 digit address (example 03), then with the locomotive not moving  select  Po and follow Digitrax Programming Mobile Decoder Addresses instructions to program address 03 to address 1000.
 
Once programmed, if you can run the locomotive using address 1000, then with the locomotive not moving  select Po and program address 1000 to the 07 address you want.

Addressing restriction is not applicable when using a Digitrax programming mode other than Po - Operations Mode Programming.
Logged
Kevin Strong


View Profile WWW
« Reply #2 on: September 11, 2017, 02:44:25 PM »

Few (any?) decoders allow you to change the DCC address (CV1) in ops mode. You have to be in service mode to do so. I don't know the Digitrax system, so I don't know its various programming modes. You do mention you have a computer for programming; might I presume JMRI? You should be able to use that to change the decoder address. Just make sure the Climax is the only thing connected to the DCC output of the computer when you do so.

Later,

K
Logged

Hunt
?
MBB


View Profile
« Reply #3 on: September 12, 2017, 05:46:19 PM »

an aside ---


K ...

There are a few stumbling blocks when programming a decoder made by SoundTraxx depending on what Digitrax DCC equipment is used. Even some specific to the use of JMRI and Digitrax.
Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!