ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
November 17, 2017, 07:01:33 PM
Home Help Search Login Register
News: Check out the photo gallery link above or >click here< to see photos of recently announced products!
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  On30
| | |-+  Trouble programming locos
« previous next »
Pages: [1] Print
Author Topic: Trouble programming locos  (Read 328 times)
palallin

View Profile
« on: September 28, 2017, 10:36:24 PM »

I have the Bachmann EZ command set, and I am having trouble programming two locos with new addresses.  One is the Tweetsie Ten-wheeler, and the other is the BLI C-16.

These are the instructions from the .pdf ont he website:
To program your locomotive to another address, first activate the locomotive by running it a short distance. Next, press button 3
(figure 8; the locomotive’s default address) AND the “Stop” button (figure 9) at the same time, then release them together. The
power LED will flash quickly to indicate you’re in programming mode.
Choose a new address for your locomotive and press the corresponding button. The locomotive will move slightly (figure 10) and the
power LED will flash slowly to indicate that you have successfully programmed your locomotive to its new address. Finally, press the
“Stop” button to exit programming mode.

Everything seems to work till I get to "Choose a new address . . ."  When I press another button, nothing happens, no slight movement and no change in flashing of the LED.  When I hit Stop again, the loco still has the address of 3 (neither has ever been changed from the default). 

Any help/suggestions will be much appreciated.
Logged
dutchbuilder


View Profile
« Reply #1 on: September 29, 2017, 03:59:30 AM »

i have no experience with Bachmann controller, i use Lenz equipment.
I can't program an locomotive address in track mode , only on a programming track in program mode.

Ton
Logged
Yardmaster
Administrator


View Profile
« Reply #2 on: September 29, 2017, 01:34:09 PM »

When you press the address and stop button try pressing down the address (3) and hold it down - then press the stop button while you are still holding down the address button. Then release them at the same time.
Logged
palallin

View Profile
« Reply #3 on: September 29, 2017, 01:43:01 PM »

I will try that and report back; thanks!
Logged
palallin

View Profile
« Reply #4 on: September 29, 2017, 07:54:04 PM »

Success!

Thanks for that tip, Yardmaster!
Logged
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!