ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
November 18, 2017, 08:01:55 AM
Home Help Search Login Register
News: Please read the Forum Code of Conduct   >>Click Here <<
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  General Discussion
| | |-+  Understanding the power spec on the EZ Command
« previous next »
Pages: [1] Print
Author Topic: Understanding the power spec on the EZ Command  (Read 104 times)
Grapevine Flyer

View Profile
« on: November 03, 2017, 10:14:42 PM »

I was curious about the exact spec of the DCC signal that comes out of the EZ Command, which from what I understand can be either connected to a track (to control 2 trains) or can be connected to a 5amp power booster.

It says 1 AMP. Is this 1 AMP peak or 1 AMP continuous?

Is it 14 volts?

Thank you.
Logged
Warflight

I'll be your Huckle Bearer...


View Profile WWW
« Reply #1 on: November 04, 2017, 01:10:58 AM »

I'm not using any power boost, just the EZ Command, and two "Walk Around Companion" controllers (three controllers all together, all powered by the one)

On my layout, I am running seven DCC sound engines (two Digitrax, one MRC, and the rest Factory Bachmann Tsunami "Sound Value") I am also running a DCC sound car (Broadway Limited cattle car) a DCC engine (usually either the Gandy Dancer, or the Norris, until I convert it to DCC and sound) plus, two end of track LEDs.

All are running just fine at the same time with no power booster, using the EZ Commander, plugged into EZ track, all engine lights and sound on.

Don't know if that's helpful or not.
Logged
Len

View Profile
« Reply #2 on: November 04, 2017, 06:39:32 AM »

"It says 1 AMP. Is this 1 AMP peak or 1 AMP continuous?"

It's 1 Amp maximum continuous output. The actual output will only be as much current as the devices it's powering need. So it you're operating two locos that require 0.25 Amp each, the measured output would only be 0.5 Amp.

Len
Logged

If at first you don't succeed, throw it in the spare parts box.
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!