Text only | Text with Images

Bachmann Online Forum

Discussion Boards => HO => Topic started by: ancestor754503 on July 23, 2007, 12:09:06 PM

Title: How dismantle freight tender of N&W 4-8-4 Class J ref 82105 to install a decoder
Post by: ancestor754503 on July 23, 2007, 12:09:06 PM
I have bought the nice Class J of N&W in freight version with 2 tenders ref 82015.
It is said DCC ready. So I wish to put a decoder in it.
I am unable to access to the IC board because I cannot separate the tender body from the floor. Even with the four locks open and the central screw through the floor unlatch, I cannot separate the floor.
Can some one help me?
For those who wish to have a floor picture I am only able to send to an URL.

Thanks in advance
Title: Re: How dismantle freight tender of N&W 4-8-4 Class J ref 82105 to install a decoder
Post by: GN.2-6-8-0 on July 23, 2007, 03:48:36 PM
Have you checked the exploded diagram provided here under product reference's /diagram's?
you might have missed a screw that need's removing.
Title: Re: How dismantle freight tender of N&W 4-8-4 Class J ref 82105 to install a dec
Post by: ancestor754503 on July 23, 2007, 05:01:45 PM
Yes, I have studied the diagram and found no other screw than 10367 holding the body to the floor.No one has tempted to install a decoder ?
Title: Re: How dismantle freight tender of N&W 4-8-4 Class J ref 82105 to install a decoder
Post by: doctor_boogie on December 19, 2009, 08:21:00 AM
Did you figure this out yet? I just bought this engine and don't know which decoder to buy or how to install and can use all the help I can get.
Title: Re: How dismantle freight tender of N&W 4-8-4 Class J ref 82105 to install a decoder
Post by: Pacific Northern on December 19, 2009, 06:06:05 PM
If you look carefully at the diagram you will see that each side of the tender has two taps/clamps to hold the tender to the frame.

You need to "carefully" pull one side out and lift it away from the tender frame very gently.

This is after you remove the one screw as noted on diagam.
Title: Re: How dismantle freight tender of N&W 4-8-4 Class J ref 82105 to install a decoder
Post by: bialecki on December 19, 2009, 06:34:40 PM
Well Pacific Northern, as a new member, I too have the N&W and I had the very same question. I recently purchased the Quantum Revolution-U sound decoder and I am eager to install it, so your response on how to open the tender up is appreciated. Your response is very timely.
Text only | Text with Images