Print Page - Dynamis / decoder equipped DCC Turnouts

Title: Dynamis / decoder equipped DCC Turnouts - setting up and using
Post by: HONZ on July 06, 2013, 01:13:00 PM

I recently bought a Bachmann DCC starter set which came with the E-Z Command Dynamis control system and a decoder equipped DCC Turnout.

How in the world do you program and operate the darn thing - the instructions are at best, sketchy.

Any help would be much appreciated.

Doug

Title: Re: Dynamis / decoder equipped DCC Turnouts - setting up and using
Post by: Bob_B on July 06, 2013, 09:12:33 PM

http://www.bachmanntrains.com/home-usa/board/index.php/topic,23974.0.html

Title: Re: Dynamis / decoder equipped DCC Turnouts - setting up and using
Post by: richd286 on July 06, 2013, 10:32:49 PM

press programming button on turnout, points toggle back and forth to signal programming mode

press accessory button on handheld

enter address you will use to select turnout

press turnout action button on handheld

turnout will toggle again to acknowledge

done

Title: Re: Dynamis / decoder equipped DCC Turnouts - setting up and using
Post by: HONZ on July 07, 2013, 09:52:47 AM

Thanks

Bachmann Online Forum

Frequently Asked Questions (F.A.Q.s) - READ ONLY FORUM => DCC => Topic started by: HONZ on July 06, 2013, 01:13:00 PM