will someone direct me to the location of the definitions of the pin outs of this board. i.e. "B+, train bus, voltage of the LED headlamp and rear lamp. is there a reed switch already installed in this loco...etc?
Click Here (http://www.bachmanntrains.com/home-usa/dwg/dwgs/82894.pdf)
Is the information, mainly in the last three diagram sheets, any help to you after you study the detail in them?
I have mostly wired to a soundtraxx card, the B+ I assume is for the pulsed smoke. I too am trying to figure it out. I have motion and sound working, I can program it, I just do not have the lights working yet.