Bachmann Online Forum

Discussion Boards => Large => Topic started by: RGGR on May 29, 2017, 02:21:42 AM

Title: Annie 2-6-0
Post by: RGGR on May 29, 2017, 02:21:42 AM
Where does the engineer sit please...I cannot find anywhere that fits...
Title: Re: Annie 2-6-0
Post by: Loco Bill Canelos on May 29, 2017, 11:39:44 AM
Hi,

I place my engineer figures in the right side of the cab with the right arm outside the window.  Using the small Bachmann engineer figure it is necessary to cut off the legs at an angle which will allow the figure to fit down into the space between the boiler and the right side cab wall.

Loco Bill
Title: Re: Annie 2-6-0
Post by: Joe Zullo on May 29, 2017, 02:34:25 PM
Quote from: RGGR on May 29, 2017, 02:21:42 AM
Where does the engineer sit please...I cannot find anywhere that fits...

The "Annie" is a 4-6-0.  ;)
Title: Re: Annie 2-6-0
Post by: Loco Bill Canelos on May 29, 2017, 03:02:47 PM
Hi,

Same answer as I made above works for either the Annie or the moguls or even the 4-4-0!

Have fun!!

Bill
Title: Re: Annie 2-6-0
Post by: Joe Zullo on May 29, 2017, 03:46:28 PM
Bill,

I didn't question or doubt YOU! 8)
Title: Re: Annie 2-6-0
Post by: Loco Bill Canelos on May 29, 2017, 10:32:29 PM
Joe,

I never thought you were questioning me, and of course you were quite correct the Annie has always been a 4-6-0.   I was not sure what loco RGGR had, so made the first answer as if he had and Annie even tho he wrote 2-6-0.  After your response I realized that he might not actually have an Annie but possibly one of the Moguls, so I added the additional info about other locos thinking it might be useful to other readers as well as RGGR.  I should  have been clearer as to why I wrote the second response as I did.   Sorry :)

Bill
Title: Re: Annie 4-6-0
Post by: RGGR on May 29, 2017, 11:01:23 PM
many thanks Bill
and of course the Annie is a 4-6-0  typo  sorry
Cheers
Andrew
Title: Re: Annie 2-6-0
Post by: RGGR on May 30, 2017, 01:52:01 AM
fixed i think
Title: Re: Annie 2-6-0
Post by: Loco Bill Canelos on May 30, 2017, 08:45:42 AM
Hi Andrew,

Glad it worked out, and no big deal with the typo!

Bill