Bachmann Online Forum

Discussion Boards => On30 => Topic started by: Len on May 31, 2017, 07:45:18 AM

Title: DC 2-6-0 Motor Holder
Post by: Len on May 31, 2017, 07:45:18 AM
I'm trying to replace a worn out motor on a shopping center's 2-6-0, and having a little trouble getting the motor holder bronze contacts in place without bending them all over. Is there a simple trick to this I'm overlooking??

Len
Title: Re: DC 2-6-0 Motor Holder
Post by: Len on June 02, 2017, 02:13:52 PM
Figured it out. I cut a couple of strips of plastic from a package 'window' and slid them between the motor contacts and the motor holer contacts. It kept them from snagging on each other while I got the holder in place, then slid them out once everything was locked down. The "Bumblebee" rides again! :D

Len