Bachmann Message Board

Discussion Boards => Large => Topic started by: rustypiston on September 09, 2017, 03:17:09 PM

Title: Peter Witt Trolley
Post by: rustypiston on September 09, 2017, 03:17:09 PM
Purchased this unit in 2015, ran it on my outdoor layout for about 10 minutes and put it on the shelf. Today (2017) I took the trolley out for a run and it just sits there.  The red stop light illuminates so I know its getting power. Plus my USA trains GP-7 was running moments before this I'm sure my power supply is adequate.  At first I thought I had the motor power switched off but couldn't locate any switches on the underside. After some examination I removed the bottom pan and located a number of switches. One was set for track power the others I didn't fiddle with.
I checked this forum and it was stated that there was a replacement board for this trolley. I tried the highlighted address to order a new board but that did nothing. Also there is a ill fitting loose board with a bunch of pins connecting it to the switch board, is it supposed to be "drooped down"? Hope some one out there in G scale land can steer me in the right direction.
Mike M.

Title: Re: Peter Witt Trolley
Post by: Yardmaster on September 10, 2017, 11:59:05 AM
Contact the Bachmann service department during normal operating hours. They will be happy to help you.