Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: Whiterg on November 01, 2017, 10:51:50 AM

Title: EZ Track
Post by: Whiterg on November 01, 2017, 10:51:50 AM
Does Bachmann have any intention of manufacturing either a 22" or 26" Radius Curve rerailer with wire track similar to the 18" track #44502 it already has?
Title: Re: EZ Track
Post by: Trainman203 on November 01, 2017, 11:25:55 AM
There are rail joiners with wire leads available while you wait.
Title: Re: EZ Track
Post by: Len on November 01, 2017, 12:20:36 PM
Quote from: Trainman203 on November 01, 2017, 11:25:55 AM
There are rail joiners with wire leads available while you wait.

Good luck trying to get the factory joiners off the use them!

Len
Title: Re: EZ Track
Post by: jbrock27 on January 05, 2018, 07:20:38 AM
Quote from: Warflight on November 04, 2017, 01:20:07 AM
  Getting the factory joiners off is quite simple.

Nope, not always.  For anyone interested in facts, it would behoove them to check out the multitude of posts about this very subject on this very Board (but then again most never bother b4 asking a question, cause they might actually see it has been addressed 3 or 4 times, already.....)
Title: Re: EZ Track
Post by: Len on January 05, 2018, 09:43:29 AM
Quote from: Warflight on November 04, 2017, 01:20:07 AM
...and the plug from your Bachmann controller (or a replacement plug from the parts store if you don't want to mess with your old plug)

If you use a replacement plug, unlike stereo connections that use the tip and ring, the wires for the controller plug go to the ring and sleeve (ground) contacts. Nothing goes to the tip connector. This is to prevent shorts when plugging into the controller.

Len