e-z command dynamis point accessory question?

Started by raptor106, December 15, 2012, 04:20:56 PM

Previous topic - Next topic

raptor106

hi
OK so i upgrading my ez command controller to Dynamis System and doing research and stuff it seem really really neat. now i i also saw e-z command dynamis point accessory decoder and saw video of it being use on switches and stuff. now my layout is pretty big and have few ez track manual switches. 2 are hook up to a/c power pack with green extension switch wire at one end of table. so i was wondering will this work if i hook the green wire to switch buttion that come with switch and i take that red switch wire with prongs and hook it up to the e-z command dynamis point accessory decoder device would that work. or do you need that a/c power to make it work. now i could by dcc power switches but that would cost alot and i fix all my switches to make it not derail rail cars so.     

raptor106

cool. but sound like i have to cut the black tab off the green wire.

hawaiiho

Where did you find this accessory?  I could't locate it on the Bachmann website or at any of my dealers.

Could this be something sold only in Europe?