News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Union Pacific 806 -- again

Started by elcentro, August 09, 2012, 02:51:19 PM

Previous topic - Next topic

elcentro

Unfortunately the dead motor is the unloved pancake variety --

any way to bring it back to life or replace it?

Thanks

Jerrys HO

probably cheaper to replace it. most analog engine's are selling on e-bay for next to nothing.

Jerry

JRG1951

Elcentro

The older pancake motor 4-8-4's are not very reliable or good runners. The best option is to buy a newer version of your engine. You may find some useful information here.

http://www.tycoforums.com/tyco/forum/topic.asp?TOPIC_ID=11848

and here

http://www.tycoforums.com/tyco/forum/topic.asp?TOPIC_ID=7703

Regards
John
******************************************************************************************
If you see a snake, just kill it - don't appoint a committee on snakes.  >> Ross Perot

richg

And the truck with the motor was the only truck to pick up power from the rails. I believe many, maybe not all, had rubber traction tires on the wheels.
Diesels today pickup on both trucks.

I have seen the pancake motors on ebay, but you can see a lot of old stuff on ebay.

Rich

jward

was that 806 the union pacific gp40? if so, you can get a similar locomotive new for under $50, the new one will have all wheels drive and pickup. it will run much better than the one you have.

you could probably find the parts to repair the one you have, but even then you will have a poor running  locomotive with a motor which will probably wear out quickly. the pancake motors had plastoc bearings that melt if the motor gets hot enough. when they melt, the motor shaft gets out of alignment and the motore seizes up.
Jeffery S Ward Sr
Pittsburgh, PA


Jhanecker2

Jward : the engine they were dicussing was  an  eight-four-eight steam engine . Your are right about GP-40s being reasonable priced though  J2.