ONLINE
STORE
"ASK THE BACH MAN"
FORUM
PARTS, SERVICE,
& INFORMATION
CATALOGS AND
BROCHURES

Welcome, Guest. Please login or register.
Did you miss your activation email?
September 25, 2018, 01:21:32 PM
Home Help Search Login Register
News: Please read the Forum Code of Conduct   >>Click Here <<
+  Bachmann Message Board
|-+  Discussion Boards
| |-+  General Discussion
| | |-+  Handrail problems on vintage Spectrum
« previous next »
Pages: [1] Print
Author Topic: Handrail problems on vintage Spectrum  (Read 421 times)
TRAINUT

View Profile
« on: November 19, 2017, 08:08:11 PM »

Help! I finally have a layout to run them on, so when I unboxed by 15-year-old Spectrum 8-40CWs in the Conrail paint scheme, I noticed I have to apply the handrails separately, which is no big deal until I discovered that the small tabs at the bottom of the stanchions would not fit into the matching holes on the side sills. Am I doing something wrong? I tried widening one of the holes slightly Cry with an X-acto knife, but then figured out width was not my problem, depth was. Is there a trick to this I can't figure out? I would like to get these up and running soon.
Logged
Trainman203

View Profile
« Reply #1 on: November 21, 2017, 01:41:02 PM »

Pin vise and appropriate small drill bit
Logged

Modeling the New Iberia and Northern 1945
Pages: [1] Print 
« previous next »
Jump to:  
Powered by SMF | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!