Detached black wire on dcc turnout

Started by Newegineer, September 21, 2026, 08:19:53 PM

Previous topic - Next topic

Newegineer

Does anyone know where to reconnect the "detached" black wire that is on the bottom of the dcc #6 turnout? it has a prong on it? please advise

Ralph S

 Another late response, my bad.  But if you haded already gotten that answer, then here it is again.
On my Bachmann (model 44135) No.6 DCC Turnout, the detached black wire with the prong on the underside of the track turnout is the frog-powering wire.  It is intentionally left disconnected out of the box by Bachmann.
That prong should slide into a tiny metal tab located directly underneath the track plastic, right near the frog section.   
Precaution: Understand if you are using DCC it's better if you leave it disconnected. That black wire is meant to supply power to that frog, to support prevention of stalling (losing electrical contact).   
Also note that this DCC #6 (44135) is not meant for DC powered tracks.

Lastly, Bachmanns manual/instructions is lacking this information. Maybe in the future Bachmann will add this little bit of information in those instructions for their DCC switches.

Hope this helps, although late responds.