News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu

Resetting to 3

Started by taycotrains, December 01, 2008, 10:29:21 PM

Previous topic - Next topic

taycotrains

Another problem...

I have a GE 70 Tonner that was purchased used.

The engine runs fine on a analog track,but does not respond to any
address on the EZ commander.
Is it possible someone assigned it to address on another dcc set up the the EZ Commander does not recognize ?

Is it possible to reset to factory address #3.

Thanks
Bob

pdlethbridge

usually resetting cv 8 to 8 will restore factory settings. Have a friend do it that has a more advanced system than ez command

taycotrains

Oh Boy !

Looks like I better get a better "class" of friends...all my friends run there trains
with ZWs  :)

Thanks for the tip Ill see if I can find someone.

Bob T



Hunt

If the locomotive has a digital address higher than 10, you can reprogram it to a new number. Carefully follow the procedure on page three of the E-Z Command Setup and Programming Instructions under REPROGRAMMING DECODERS WITH PREVIOUSLY ASSIGNED DIGITAL ADDRESSES.




Lost the instructions click  http://www.bachmanntrains.com/home-usa/ez_content/EZ_Command_instructions.pdf

taycotrains

Thank you Hunt !

I followed the directions that my daughter printed out and the engine is reset to 3
BT