Thanks for the info. It does work. After pressing the locomotive address button you press the yellow function button. The button that is asigned to the locomotive will begin to blink and then you can control the other functions as well as the loco's forward and reverse motion.

I bought an Intermountain EMD F7A and F7B with decoders installed. I watched it run and all functions worked properly.On my layout with the EZ Command only the direction controls and diesel engine sounds work.I have tried all other nine buttons (loco is set to 3) and can't make the lights,horn or bell work.What do I need to do? I have seen videos of these functions being operated from the EZ Command so it is possible right?

I'll take a look for those. Thanks

Good morning all. I have been wondering why is it so difficult to find HO scale pickups except for 40s and early 50s. My layout is based on the 1960s and it seems like there are hardly any pickups for that era.

I will. Thanks

So it is possible to add a sound decoder to this engine? Yes it is HO

Hello,
     I'm new at DCC. I just converted from analog with a Bachmann E Z command control center and a DCC equipped SD40-2 (60901) engine.Can I add sound to this system? If so what do I need to purchase?