is there any way to program the master volume on the H-0 E Z command unit. I recently installed a decoder in an older Diesel and the volume blows my ears off. The seller has offered to reset the unit off "Default" and lower the volume, if I return it. Before I go through the expense of shipping snd packing both ways thought best to post this on the forum.
Joe W
Joe-
No. You cannot program anything with the EZ Command except which end of the loco is the front. You can also assign a button on the control box which is a sort of programming but that's the limit. If you know someone with a DCC system other than EZ Command you can reprogram your decoder. It will then operate on your system.
-- D