News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Dave Crocker

#1
I have Emily (91404) and have just received the green Christmas coach (90087).
Emily is 1:20.3 but the coach seems to be 1:22.5.
The question is -- what is the scale of Emily's green coaches (97003 & 4)?

I am converting Emily into the Stirling Single and need coaches that are the same scale.
Any help is appreciated

Dave C
#2
Large / Bach Man - IPD's and Wiring Diagrams
July 21, 2009, 07:41:46 PM
Bach Man, Could you see if you could get Bachmann to keep the old Illustrated Parts Breakdowns and wiring diagrams on the web site.

In G-scale, the only ones still around are the active products.
It would be very helpful if all the Bachmann products would stay on the web site.
Currently, the only engines that have diagrams online are the side tank porter, the 3 truck shay and the K-27.

Thanks

Dave
#3
Large / Got 2K2 sound working with a K-27
January 14, 2008, 04:18:49 PM
I have sound working in my K-27 with a Phoenix 2K2 sound card.
The only problem left is that the sensors on the left side (I think) are not positioned exactly correct and I get 4 chuffs and a slight space.

I got my K-27 at the end of last week and spent all my time trying to get the optical sensor to work. The engine was going to run at the Del Mar Worlds Greatest Hobby on Saturday  so I ended up running this weekend with voltage controlled chuff.

The engine performed very well, I was pulling 24 cars around the DelOro layout without any slippage.

The optical sensor puts out a low going high voltage on chuff and the Phoenix expects to have it's high pulled low.
The solution is to install a NPN transistor (Radio Shack 2N2222 works fine) with its collector connected to the Phoenix chuff input (pin 15) and its emitter connected to ground (pin 16 and the K-27 ground (J1-5). Now connect the base to the chuff signal from the optical sensor (J1-7). This inverts the signal so the Phoenix board responds.

The optical sensor has another problem though. It doesn't respond with valid chuffs until the track voltage gets up to 4 volts. The engine starts moving on about 1.5 volts and runs at prototypical speed at about 9 volts so the engine has no sound as it starts. To get around this, as a test,  I installed 5 diodes in series with the motor. These diodes drop about 4 volts and require the track voltage to be above 4 volts before the motor starts turning.

I cut the trace on the plug-in board between one of the chokes and connector pin.
If this becomes permanent, I will have to install 5 diodes in the opposite direction as well or see if I can find an appropriate Zener.

Now I have to take the cylinder area apart and see if the optical sensor board can be moved to get a correct sounding sequence.
If this can't be accomplished, I'll have to fall back on installing magnets.