I just purchased a Overland limited set for my son and me for Christmas. I would like to attach the track to a 4'x 8' sheet of 3/4. My question is how can you attach the ez track directly to the plywood...or should i let the track sit freely. I'm only adding a few details to start out so me and my son can build on it in the future.
Thanks, Tim
With E-Z Track, you can let it sit free. This allows you to easily try different track configurations without having a problem of track sections coming apart. If you find a setup that you really like, you can glue the track to the plywood but even then you might want to go easy with the glue so that change is still possible.
Jim
Thanks Jim, Im looking forward to getting it set up this week. My son has been hooked on trains since he learned to walk and now i believe im as hooked as him!
Jim how well will hot glue hold EZ Track down . I was reading a previous thread "Securing Track" I did a search when I saw this thread . I'm still trying to decide how I want to anchor my EZ track down as well .
Hot melt will work well. An alternate is Aleene's Tacky Glue available in the crafts section at Wal-mart, craft's stores, and on-line. Either will hold well, yet is fairly easy to remove without damaging the E-Z track.
I was thinking about little screws but I'm not sure they can be found thin , long , and strong enough ...but if so they would be able to be removed with no problem
I was thinking of screws also but had no luck finding anything that would work. Im going to give the glue a shot.
thanks, Tim
Quote from: tstack on December 14, 2009, 11:20:17 PM
Thanks Jim, Im looking forward to getting it set up this week. My son has been hooked on trains since he learned to walk and now i believe im as hooked as him!
This just goes to show that model railroading is hereditary. You can get it from your kids. ;) :D
Welcome to the fraternity. :)
As I noted in another post tonight on a different thread, in N scale I would cover the track with ballast, spread it out, then spray and/or drip a mix of rubbing alcohol, elmers and water. After it dried out, it held the track down and the alcohol spread the glue all through the ballast.
If not using ballast I would still think rubbing alcohol mixed in with the glue would help it spread better than detergent.
I'm sure that "sensible people will disagree" with this approach but it worked for me.
Jim
Jim,
That's a good method, however he is using E Z track and your ballasting will not really help hold down the track as it is already attached to the base. The hot glue is probably his best bet.
I forgot to mention in this thread that I was using N scale Kato Unitrack with track attached to a grey plastic roadbed, very much like EZ-track.
The glue/alcohol/water mix worked very well holding the plastic roadbed to the foam and plywood surfaces, and the ballast made the track look that much better.
I had a nice little 10x10 empire built in N scale, too bad I had to tear it up when I moved.