I'm running all Bachmann products on my N scale layout. I have the EZ Command Plus with DCC turnouts and the Bachmann 5 amp booster. My locomotive obviously receives signal as I can change sound and lighting. As soon as I apply throttle power it jerks forward and stops. Any suggestions?
When I have that problem, I check the drive train for defects and repair if any, find someone whith a controller that can change CVs and reset the decoder to factory (soundtraxx cv8=8 or cv 30=2). Every time the sound works, and the motor control doesn't work I have sorted out the motor control. I remove the decoder and install it in a dummy engine for sound effects. and install a new one in the locomotive. I would recommend you have your decoder tested Before you go replacing anything.
Check with Bachmann service department, or a local Hobby shop that has repair service.
Bachmann Service Department
Repair inquiries, or general inquiries may also be sent to:
Bachmann Customer Service
1400 East Erie Avenue
Philadelphia, PA 19124
Bachmann's Service Department is available Monday through Friday from 8:30 am to 4:00 pm (All Times Eastern). Customer Service for all scales can be reached at 215-533-1600 or Fax at 215-554-6734.
https://www.bachmanntrains.com/home-usa/service.php
I own a ez command controller all functions work but locomotived have stopped moving any suggestions?
If it's a steam locomotive, something in the rods and valve gear might be catching and jamming.
This is a NCE 0219 Decoder Tester Kit. The decoder tester works with ANY DCC decoder. Test for motor forward and reverse, functions F0F, F0R, 1, and 2.
(https://images34.fotki.net/v1681/filexElN/97746/4/4125954/16375553/Picture2.jpg)
The trains move using a different controller ordered the new plus
?