Hello, I have a couple questions that I have searched the web and cannot find the answer. I have 4 DCC remote crossovers and 1 remote turnout using a decoder for DCC. Every time I power up the crossovers all open to crossover but the remote turnout does nothing. If they are already open they do nothing, kind of a problem remembering to not park the locos on the crossover every time I shut down and remembering to close every time I start up. Almost sent 2 very good locos to the concrete yesterday. Any idea if this can be stopped? using EZ Command
The other question concerns the EZ command I/O Port. The manual has no info and was curious if I connect another EZ Command what would happen? Would it work as a another throttle, I assume it would not allow me to program 8 more locos and turnouts. Also is there a specific cable needed, searched for one and nothing.
Thanks in advance.
The other question concerns the EZ command I/O Port. The manual has no info and was curious if I connect another EZ Command what would happen? Would it work as a another throttle, I assume it would not allow me to program 8 more locos and turnouts. Also is there a specific cable needed, searched for one and nothing.
Thanks in advance.