Well, I have searched this forum and have not found the answer.
I just received an EZ Command Dynamis controller and it works well as long as you do not try and change the Loco address. I have followed all the steps and I cannot get it to work on anything but the default of "3". What should I do or is this a factory problem?
Also I noticed that the signal strength is weak, you have to have the controlled within 5 feet of the receiver.
-I have watched the Bach vids and changed the batteries.
-I have followed all instructions and when I hit the program button the display shows the change in address but the engine will not respond (unless on 3)
I really like the features but the main reason I purchased this controller was the ability to operate multiple engines!
Any help is appreciated!
I just received an EZ Command Dynamis controller and it works well as long as you do not try and change the Loco address. I have followed all the steps and I cannot get it to work on anything but the default of "3". What should I do or is this a factory problem?
Also I noticed that the signal strength is weak, you have to have the controlled within 5 feet of the receiver.
-I have watched the Bach vids and changed the batteries.
-I have followed all instructions and when I hit the program button the display shows the change in address but the engine will not respond (unless on 3)
I really like the features but the main reason I purchased this controller was the ability to operate multiple engines!
Any help is appreciated!