I am unable to change the address on either of my bachmann locos. The last time I used them they were address 1 and address 2. Today the address 1 Loco is still working fine but the address 2 Loco is now on address 3 and it has its directions revirsed. I've went through the steps of changing the address on both locos but neither will take a new address. Any info would great
The key to successful programming a locomotive's address using the Bachmann E-Z Command Control Center (Item No. 44902) is the sequence in which buttons are pressed, when a button is held down and when the button is released.
The procedure in section PROGRAMMING A LOCOMOTIVE TO A SPECIFIC ADDRESS is normally used to change address when locomotive current address is in the range 1 through 9. When experiencing problems using the normal procedure, try the procedure in section REPROGRAMMING DECODERS WITH PREVIOUSLY ASSIGNED DIGITAL ADDRESSES, page 3 in the Setup and Programming Instructions.
If needed -- Click Here (http://www.bachmanntrains.com/home-usa/images/E-Z_Command_instructions.pdf) for PDF of the latest version of E-Z Command Setup and Programming Instructions
Thanks Hunt. They are both running prefect again now. It also fixed the light on 1 of them.