News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Blackie

#1
On30 / Re: Wiring diagram
February 14, 2019, 01:16:26 PM
Hi Hint,

This is exactly what I was looking for, thank you very much.

Blackie
#2
On30 / Wiring diagram
February 13, 2019, 02:16:43 PM
I'm looking for a wiring diagram for installing the sound board into my Forney. I have already contacted Soundtraxx, (I got the board from Bachmann in 2016, I'm just now getting around to putting it into the DCC ready engine). Soundtraxx told me to for the wiring I'll need to talk to Bachmann. is there a wiring diagram that shows were to solder which wires to which place on the sound board and the DCC board? The only solder points labeled on the sound board are the for the speaker.
Thank you in advance for your help
Blackie
#3
On30 / Re: Forney sound board.
November 07, 2016, 09:13:30 AM
Thank you Hunt,
All your information will be very helpful.
Blackie
#4
On30 / Forney sound board.
November 06, 2016, 12:32:41 AM
I have the Forney DCC only, I bought a sound board from Bachmann for this engine. I see that its a plug and play, I would like to know where to plug the speaker into. Also what is the best speaker for this engine, for the very best sound.

Thank you in advance for you help
Blackie
#5
Large / Re: Scale question
July 16, 2010, 09:01:34 PM
Thankx to all the replies to my question about scale. Sorry it took me so long to reply, I have been very busy.
Thankx again
Blackie
#6
Large / Scale question
July 09, 2010, 05:28:37 PM
I was wondering what scale is the Large scale trains? I'm thinking it is 1:24, but I would like to know for sure. All the Bachmann box's and adds I have seen don't say what the actual scale is. Then again I might have missed it some where.
Thankx for any help
Blackie
#7
On30 / Instruction sheets
April 13, 2010, 05:09:59 PM
I would like to get a complete set of instructions for the 2 truck shay.
Before I could print them from your web sight, but I see that I can not do that anymore.
Thankx for your help
Blackie