Is the Roco Multicentral Pro controller and Rocomotion software compatable with Bachmann DCC turnouts?
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
HO / Bachmann DCC turnouts & Roco Multicentral Pro and Rocomotion compatability
May 18, 2011, 12:00:42 AM #2
HO / Degrees of curve to run parallel track from a #6 turnout
May 05, 2011, 04:40:39 PM
I am using 35.5" and 33.25" curves to construct two parallel tracks. I am using #6 DCC turn outs and crossovers.
How many degrees of 35.5 or 32.5 curved track do I need to run a parallel track from the #6 turn out?
How many degrees of 35.5 or 32.5 curved track do I need to run a parallel track from the #6 turn out?
#3
General Discussion / Which DCC chip for Bachmann China CRH3 trainset?
February 05, 2011, 04:13:39 PM
Can anyone advise me which DCC decoder do I purchase to change my Bachmann CHina CRH3 trainset to DCC?
thanks
Graeme
thanks
Graeme
Pages1