Does anyone know the diameter of the drivers (not the prototype) in either in mm or inches on the model?
Measuring with calipers I get .318 in. against the flange.
James,
Thank You. i'm building a Winans Camel using the Bachmann 4-4-0, but in scale the drivers are too large and the 0-6-0 looks like they will be closer in scale size.
John
Check my math.
50 - 51in ?
James,
Your math is correct, the Winans Camel had 43 inch drivers, and the 0-6-0 is as close as I can come. Thank you again.
John
I recall measuring the drivers on the MDC 2-8-0 many years back. They scaled out to forty-eight inches. I can not find my calipers, right now, so I can not be sure, any more. Athearn now sells the same locomotive. If I can find my calipers after I get back from the Nationals game, I will measure them, again. The 2-8-0 in question does have both middle pairs of drivers blinded.
Those things had various wheel arrangements, including an 0-8-0. I do not know if the dimensions of the MDC/Athearn locomotive might match some of the Winans. I would expect not, as the MDC/Athearns are 1880s power.
Still, if my measurement was correct, the MDC/Athearn drivers are two to three scale inches closer to the Winans drivers.
brokemoto,
That would be great if your estimate is correct, thank you for your thought.