I am replacing the drive shaft on my Shay and have run into an issue.
I followed the pictoral on the Railroad Line Forums showing how to release the clips. On the
back side of the clips, I only see two holes with no prongs to press in to release the clip. I have pushed
into the holes with no luck of releasing anything.
Has anyone run into this issue? Any suggestions?
THanks,
Bill
I tried sending a couple small pictures, but it said the upload folder is full!?
Bill,
I sent you a private message with my email address. I wrote the SBS on the RR line site so I should be able to help you.
Larry
Quote from: locobill on December 09, 2013, 06:21:41 PM
I tried sending a couple small pictures, but it said the upload folder is full!?
No pictures can be uploaded. S.O.P. Standard Operating Procedure. Unfortunately Bachmann will not tell users that. Kids would swamp the gallery.
Get a Photo Bucket account for uploading photos. Not difficult to do. Use the fourth link, titled, IMG.
http://photobucket.com/
Rich