I am a complete illiterate when it comes to dcc. I don't understand what a CV is.
I want to change the whistle sounds on one of my Heislers to make them easier to recognise.
How does one do this with an EZ Command controller? What buttons do I need to push? I have looked and looked on the instruction sheets but I can't find how to do this.
or can I do this?
TIA
The value in the decoder's CV 115 Whistle Selection, controls the whistle sound used.
The Whistle Selections are
B&O 3 Chime (Default, CV 115 = 0
Peanut Whistle, CV 115 = 1
D&RGW Single Chime, CV 115 = 2
Bachmann E-Z Command Control Center does not support programming by user supplied CV number. Thus you cannot use it change whistle selection.
Quote from: Linzthom on October 17, 2015, 08:11:00 PM
I am a complete illiterate when it comes to dcc. I don't understand what a CV is.
. . .
TIA
Click Here (http://www.soundtraxx.com/manuals/tsunamisteam_users_guide.pdf) Starting on page 6 is one of the better tutorials available about the DCC decoder's CV - Configuration Variable and programming it.
Right, Hunt. Thanks for that. So EZ Command is only good for default, as supplied, dcc. Ah, well. :-\ :-\ :-\
Hunt, thanks so much for that link. have looked all over and never could find it, but it is exactly what i need at the moment.
thanks
jim
atlanta