I have purchased a few N scale vandy tenders used with the Heavy Mountain I would like to use them with the ConCor 2-10-2. I can figure out how to couple them but I need help with installing a decoder. The tenders did not come with any information about the circuit board installed or how to install a decoder. There is a series of 6 pins on the board that looks like a decoder might plug into that; there is also seven points along the side of the board numbered 8 -1 - 2- 4- 5- 6 - 7 that looks like a decoder could be soldered there. Any information would be helpful. Thanks.
Look here -
http://www.bachmanntrains.com/home-usa/dwg/dwgs/N821X-IS001.PDF
It's not the Mountain but the number code is the same on the boards. The same jumper clips are used on all the new loco's.
Another reference to a loco that uses this wiring scheme -
http://www.bachmanntrains.com/home-usa/dwg/dwgs/N614X_IS001.PDF
Install in new steam
also bumped to top
http://www.bachmanntrains.com/home-usa/board/index.php/topic,1182.0.html (http://www.bachmanntrains.com/home-usa/board/index.php/topic,1182.0.html)