I have On30 Bachman passenger cars and I need to raise up the car so the couplers

will match. These trucks are not attached using a screw, so how can I remove these

trucks to insert a washer for spacing.

Thanks

Jack

I have a new Bachman ON30 trolley. Instead of a power pack, this thing is equipped with

an on/off switch only which has only speed --slow. This replaced last years HO Trolley

which worked just fine. Also, I can only get intermittent operation, sometimes it

quits in the middle of the run. So far not much fun.  Any ideas??

Thanks

Jack

I am looking for software or CAD programs enabling the planning
of smaller layouts, also looking for software or stencils for re-naming
rolling stock and or buildings.

Thanks---Jack

Following up on the discussion regarding changing lettering on rolling
stock, is there software and or label products for making such changes.

Thanks---Jack