@trainman203 - CV2 is the start voltage...determining the motor speed at step 1
I have never seen any factory or installed decoder with a default CV2 setting of 0
In fact...most mfgr's recommend anywhere from 2 to 26 for CV2 depending on the typical use of the loco
I already have CV3 and CV4 set where I want them tyvm
@jward - Yes they are DCC OnBoard units...I kinda suspected they may not be adjustable
They are not perfectly matched but very close
I have never seen any factory or installed decoder with a default CV2 setting of 0
In fact...most mfgr's recommend anywhere from 2 to 26 for CV2 depending on the typical use of the loco
I already have CV3 and CV4 set where I want them tyvm
@jward - Yes they are DCC OnBoard units...I kinda suspected they may not be adjustable
They are not perfectly matched but very close