Text only | Text with Images

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: ejseider on December 26, 2010, 09:57:31 PM

Title: Overland Limited Set-up, power to switches
Post by: ejseider on December 26, 2010, 09:57:31 PM
I'm setting up the Overland Limited kit that I received yesterday for Christmas.  I also received a Track Pack.  Two questions:

1) The controller does not have terminals to connect for power to the switches.  How can I get power to operate the switches?

2) The Overland Limited has six plastic sticks each of them one inch long packed in the Styrofoam that with the cars.  There is no mention of these in the instructions that came with the kit.  What are they for??
Title: Re: Overland Limited Set-up, power to switches
Post by: Jhanecker2 on December 27, 2010, 07:00:35 AM
the one inch long sticks are for the log car .  They should have a small tab at one end that can be inserted & glued or fastened to the holes in the deck of the log car on the top surface . J2
Title: Re: Overland Limited Set-up, power to switches
Post by: Bluecoatscheesypoofs on December 28, 2010, 12:50:44 AM
1) The remote switches are powered by the accessory outputs on you Bachmann controller. The two wires from the switch fit into them.

2) The six plastic sticks that come with the set are for the log car. If there are already posts in the log car, These are spare pieces.
                                                                                         Good luck,
                                                                                                    Matt Wilson
Text only | Text with Images