I have an all-Bachmann DCC layout with DCC turnouts, turntable, etc.  I upgraded to the Dymanis, which runs all my locos and the turntable fine.  However following all the instructions, to program and switch the turnouts with the Dynamis, it neither switches them nor programs them.  My DCC Command Controller does, but not the Dynamis.

I made a video of a simple layout with one DDC engine and one DCC turnout, demonstrating how the DCC Command controller ran the gear, then attached switched the layout to the Dynamis.  Loco worked, accessory turnout - nothing. 

What's the secret?

I have a fairly extensive 100% Bachmann HO DCC 5' X 8 ' layout, with reversing loop, motorized turntable w/ Tidmouth Shed, main, siding, a/d track, etc. (landscaping to come later), but cannot see all my DCC Turnouts and therefore am trying to find information on adding signal lights to my Bachmann DCC Turnouts to avoid derailments.  Do you have any recommendations on how to wire in functional signal lights onto the 44130 and 44131 EZ Command DCC Turnouts?