i have tender with high coal load in front. can't find any screws on underneath. how does shell come off
Is this your tender?
https://www.bachmanntrains.com/home-usa/dwg/dwgs/N_BALDWIN_4-6-0_EXPLODE_DRAWING_N514X_(3).pdf
Rich
yes. i have 2 one dcc and 1 dcc with sound one with sound has bad engine so need to get apart to change
Mine are just a friction fit. A tight fit but the shell will pop off, you may need a small screwdriver blade between the shell and frame to start the process.
thanks i found the coal load pops out then can get to screw that frees shell and dcc board, but that on good loco tender. now bad loco and tender i want to keep coal pops off but dccw sound is in tight and i gues sound part is covering screw . this is tender i want to keep . might have to find someone to pay to do it.
The tender shell for the 4-6-0 is not held by screws... it is just a (tight) press fit. Find the fine "crack" between the tender frame/chassis and the shell... gently slide the edge of a hobby knife into the crack, and gently wedge the shell upwards. You might have to work on both sides before it pops loose. It's likely you will loose just a little paint from the frame/chassis, which can be touched up with engine black acrylics. Good luck.