Dear Bach-man,
Thank you very much for the fast answer!
Best Regards
Zdenko
Thank you very much for the fast answer!
Best Regards
Zdenko
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#17
General Discussion / EZ-command question about steps
February 18, 2009, 01:50:06 PM
Hello!
Recently I bought EZ-Command with 2 Bachmann DCC decoders ( default 28 steps on speed). I have one decoder from Hornby, programmed at 128 speed steps. For EZ, in manual says 28/128 steps. Does it mean that it can run both 28 and 128 steps decoders or I have to change CV on Hornby?
Thank you in advance and Regards to all members!
Zdenko, Toronto
Recently I bought EZ-Command with 2 Bachmann DCC decoders ( default 28 steps on speed). I have one decoder from Hornby, programmed at 128 speed steps. For EZ, in manual says 28/128 steps. Does it mean that it can run both 28 and 128 steps decoders or I have to change CV on Hornby?
Thank you in advance and Regards to all members!
Zdenko, Toronto