Hi folks, I'm getting ready to install my new die cast trucks and have a question. Prior to hooking up the new truck wiring, is there any reason that I can't determine correct phasing of both the wires to the trucks and also the wires going into the locomotive by applying track transformer power to the wires directly where I will be making the solder joints?
Thanks
Dear gypo,
It would be safer to use a Volt-Ohm meter at the lowest Ohms setting to trace out the wiring
before touching power to the wheels.
Hope this helps.
Sincerely,
Joe Satnik
Thank you Joe. Sorry it took so long for me to reply. I'll let you know how it works out. Thanks again.
gypo r.r.