I also had trouble with derailments using e-z turnouts. Then i grinded off the inner upper flange of the rail where the point touches. That fixed my problem. Did it on all of my turnouts all work great now.

Thanks for tha advice, it worked. Check before you solder the wires so you can get the correct set. Both switches work with no problems but if stops working as I add more switches to my layout I will add the electronics you mention.

Hello

Just received my Crossover Turnout and was wondering if I joined the 2 groups of 3 wires together (2 middle wires, 2 left wires and 2 right wires) and then use 1 plug would I be able to have both switches go straight or go to the curved route at the same time. I would not like having any damage done to anything.

Has anyone done this?

Thanks