Has anyone had trouble with setting up the tt in either dc or dcc.I cannot get it to work either way.I don't have directions.

I have just purchased a Bachmann Alco FB2 Diesel Loco With Sound.
When I put it on the track it runs,but no sound.I am using the e-z command system.I pushed the function button along with #10,however nothing happens. Any ideas?

I am looking for a dcc command unit that will run both dc and dcc including all the sounds in those dcc engines.
Will the dianamis system do this?

I have a prodigy express dcc controller and I want to use my bachmann power booster #44910 in compatibility together.How can you do it?

I have a FA2 DC I want to convert to DCC. I have a 8-40 pc board I want to use.I also have the decoder.All Items are bachmann.

I have a 44902 dcc command system that is hooked into a dc 44212 power pack suggested by bachmann to run dcc & dc at the same times.Problem is when I run them together they both slow way down. Is a$300.00 5amp booster needed to operate efficiently?

I have a#60121 NYC emd ftb with dcc equipped.It came programmed on 3, and ran in both directions.I reprogrammed it for 1,now it won't run in reverse. I tried reprograming it back to 3 to run with the fta unit. It won't run in reverse. What am I doing wrong?

I recently purchased a new dcc transformer/controller,
I have 2 questions
#1  how do you hook up switches to it--
#2 how do you know what functions each engine has 

Has anyone seen or heard of a coupler replacement,knuckle type for these trains?

Is there a better way to uncouple and couple  these cars without tipping them on their side?

I have a bachmann Plus set of #11325A & 11326B units,brand new,but the B unit runs faster than the A unit Bteaking them in did not change anything. What do I do now?