I have a E-Z Command control center that will not let me program my DCC equiped engine to a new address. I am following the programing instructions. Can anyone help?
I had the same problem when I purchased my E-Z Command. I found that the instruction booklet was incorrect and when I downloaded the instructions from Bachmann there was a slight ,but significant difference. Try and print the following: www.bachmanntrains.com/home-usa/ezcommand.php?ezpage+1
The last part of the address should read: ....ezpage=1
Quote from: johnspat1 on August 29, 2011, 12:46:00 PM
I had the same problem when I purchased my E-Z Command. I found that the instruction booklet was incorrect and when I downloaded the instructions from Bachmann there was a slight ,but significant difference. Try and print the following: www.bachmanntrains.com/home-usa/ezcommand.php?ezpage+1
Great information. I just unpack my E-Z Command controller and the same thing (as above) happened. I too downloaded the corrected instructions and now everything is fine. Great Forum with great members. Thanks.