Thanks to all. I will use the delay the start by 3/4 in and that is easy to do.

Thanks. I am trying to tuck a siding in a tight area.   

Do you have enough clearance for trains if you put a 22 inch turn beside a 24 inch turn.

On Feb 22 2007 another person had the problem.

The screws are tight. I am not turning the truck it simply hits the foot board. Lowering the foot board more than about 1/8 inch will cause it to drag.

It is just below the coupler. It might be a place to stand. The coupler shank hits the plastic cross part under the coupler shank on both ends. The picture shows it under the coupler and just almost touching the rail.

I have a Bachmann Shay with the original trucks. The couplers hit the front and rear bumpers. How do I fix this problem. The model has been in a dis[lay and I was going to run it but it has broken both bumpers.

Bill

Is anyone aware of a site to hear the new sound system?

Thanks for your assistance. Bill

I am new to the hobby. What do I need to do to insure continued good performance. I have run it about 4 hours so far? What lubricants are needed and where?

I just keep looking for CSX

You are correct 4 axle GP units. Thanks

Will Bachmann make a sound equipped 4 axle diesel soon?

I am interested in installing a sound board but cannot find room for a speaker. Will Bachmann make a GP38-2 with sound soon?

Thants  I just did not have any instructions with the new car.