I'm not sure if I'm missing a piece on my K-27 or it's prototypical (whatever it might be).
On the right side inside the cab, beneath the engineer seat there are 2 pins just above the floor boards. Are those pins in place to hold a detail part? They just seam to be out of place.
Also can someone recommend on which Labelle lubrication I could use for my first run. I have 102, 108 & PTFE grease sitting around. Not sure what is appropriate.
Much Apprecited
Dear lq,
I'll have to check a cab to see.
As long as your Labelle lubricants are plastic compatible they'll be fine. I don't know which numbers correspond to our lubricant weights.
Have fun!
the Bach-man
:-\ Sorry it was pointed out to me it was a detail from outside of the cab. I did not think any detail part would intrude inside the cab like that. My bad.