How do I get my ez command to work my other manufs. dcc equiped engines?
I program them on the "Program Track", that is a siding, that I have isolated. I just follow the NORMAL directions, that are in the EZ-Command manual. I have not had any problems...
Quote from: beachaccess on February 26, 2010, 10:00:24 AM
How do I get my ez command to work my other manufs. dcc equiped engines?
The same way you get it to work on Bachmann DCC on board locomotives. If the locomotive has an address between 1 and 9, use its address. If it has a higher address, program it to an address between 1 and 9 using the directions in the manual for programing a locomotive with an unknown address. This will usually work but there are exceptions, particularly if the bought the locomotive used.
Jim