The new steam generator car by Rapido,
has smoke that's supposed to be steam
directed down to the rails.
Is this leaving a residue on the tracks?
Jim

My friend who uses NCE was showing me a snubber schematic. Then I see it in the Sept. M.R.
The cap is mis labled should be 50-150 volts not ohms.

I am using Digitrax radio but the brand is irrelevant.
I have now installed this on my layout.
Anyone else bothered to assemble and install one?
Any point?
Jim in Kelowna B.C.
   

 My Bachmann motor with brass flywheels on each end has developed a flat spot.
I have to give the motor a spin to get it to go.
I was thinking I would like to get it apart to see if there is a wire off one of the segments or just to see if I can find the problem.
Anyone had one of these apart?
Removing one brass flywheel could be a problem, ideas?

Bachmann sent me a new motor,and the old one back as well
so this one is something I can pull apart.
Jim

Some of the older Bachmann units like the SD-45 GP-35 that are
DCC on board show 28 speed steps written on the box.
No mention if this will only support 2 digit address
or if one can program a 4 digit address on a 28 speed step unit.
Is this limited to a 2 digit address?
Thanks, Jim