I'm using Bachmann EZ track and all of my turnouts and crossovers are DCC. I am running this with Digitrax DS51, but I would also like to start using JMRI PanelPro to control the turnouts. I have ordered a USB interface to connect to the system with JMRI.
I can program my Bachmann DCC turnouts with my Digitrax DS51 to assign addresses to them. I would like to figure out how to do this through DecoderPro. Is this possible? If so, how do I do it?
Quote from: rpray on December 02, 2014, 04:50:31 PM
I can program my Bachmann DCC turnouts with my Digitrax DS51 to assign addresses to them. I would like to figure out how to do this through DecoderPro. Is this possible? If so, how do I do it?
I believe the short answer is "Yes" but as I do not use, at the moment, powered switches I'm afraid I cannot help.
However, if you subscribe to the Yahoo Group jmriusers@yahoogroups.com you'll find lots of helpful people.
Cheers
Roger T.