I have a DCC ready Vandy tender and a few of the ten wires that go to the engine have broken off the board. Where can I find a diagram that will identify where these wires are soldered to the board? Thanks.
Richard
Here is the long Vandy tender diagram: http://www.bachmanntrains.com/home-usa/dwg/dwgs/89912.pdf (http://www.bachmanntrains.com/home-usa/dwg/dwgs/89912.pdf)
Here is the Hicken Vandy tender diagram: http://www.bachmanntrains.com/home-usa/dwg/dwgs/89912.pdf (http://www.bachmanntrains.com/home-usa/dwg/dwgs/89912.pdf)
If what you need is not there then you are out of luck, so hopefully it is there.
Get an inexpensive multimeter and use the resistance scale to ring out the leads. I do that a lot just to see what the PC board wiring is like. Don't attempt working at this level in DCC without a multimeter.
Rich