News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - bozz

#1
General Discussion / Wiring Wye Switches
October 09, 2007, 06:06:22 PM
 I am working on my first train set.  I hope to have 6 wyes  in this layout. My control panel is going to be a slide out under the main table. The wire on the wye is too short  to go to the panel.   Is there a jumper I can get or do I need to butt splice them to put  the switchs on the panel?
#2
General Discussion / Re: guilty! 4 pics
October 09, 2007, 05:31:18 PM
im new at m/r but what you have done makes me lite up thaks
#3
HO / turn radius
October 06, 2007, 08:15:25 PM
Have Class J 484 Freight Locomotive.  Hoping to find out what degree turn radius I need
#4
General Discussion / Re: I'm new - please help!
September 06, 2007, 04:26:42 PM
RAM,
I'm going to have DC and DCC on the same track and run more than one train at a time - on a 4x8 sheet with over loops and cut offs.  Also 2 side by side straights and 2 curves
#5
General Discussion / I'm new - please help!
September 06, 2007, 02:01:39 PM
I'm new at train works and need help with a few initial things.  I'm going to mack a track layout on a 4x8 table.  I understand that I'll need more than a 1 amp transformer to feed all this track.  Questions:
Can I use a 3 amp battery charger as a transformer?
If not, how much track can I feed with a 1 amp transformer?
Can I feed a number of trains on one track?
Can I feed a number of tracks on the same table?
Please help me get started!