Thank you Hunt. You just saved a piece of 9" from being chopped up!

Quote from: Hunt on November 19, 2008, 04:02:44 PM
Bachmann has, to date, not provided the geometry of its track except for curved track and the track code. All HO gauge is code 100.

HO #6 Remote Crossover -- 2-3/8" between centerlines, 21-1/4" long

So if I want to use this #6 Remote Crossover on one side of a double loop, is there no 3 1/4" piece available to fill in the gap on the other side of the double loop?

~ Dave

I keep a big ol' magnet handy, for just such occasions. You'd be surprised at what comes out of carpet heaven. Got my retrieving magnet at harborfreight for about $15.

They're pins, and those SOBs were in TIGHT!

Never mind, I found the answer  

I tried to disassemble my 0-6-0 for cleaning and a lube job. One cylinder broke off, so I ordered these from Bachmann:

http://estore.bachmanntrains.com/index.php?main_page=product_info&cPath=66_68_155&products_id=866

They have a few more rods on than the originals, but I would have to remove the old rods from the drivers first. Is that a pin holding the rods on or a screw? The head is round.