I am getting a squeek on curves that I can not locate the source of. This is on our club layout with 11& 12 ft diamiters. Has any one else had this? I am leaning towards blaming it on driver flange squeell. If that proves to be the source I am wondering what will happen this summer when I put it on my home layout with 8 ft curves.
look here
http://www.largescalecentral.com/LSCForums/viewtopic.php?id=8242 (http://www.largescalecentral.com/LSCForums/viewtopic.php?id=8242)
or here
http://www.largescalecentral.com/LSCForums/viewtopic.php?id=8249 (http://www.largescalecentral.com/LSCForums/viewtopic.php?id=8249)
hope that helps!
cale
my k also sqweeks in the 6 1/2 foot curves and also makes a low ka ka ka in reverse. my k is more than well lubed and this drives me nuts! i think the best we can do is run them till they blow and through them in the lake or make bird feeders out of them. bob.
The noise in reverse might be mitigated by repositioning the johnson bar!
Seriously I have heard that the position of the reversing gear linkage affects operation and noise.
TOC would know for sure.
Regards, Greg
Quote from: spla13 on April 04, 2008, 02:48:58 AM
my k also sqweeks in the 6 1/2 foot curves and also makes a low ka ka ka in reverse. my k is more than well lubed and this drives me nuts! i think the best we can do is run them till they blow and through them in the lake or make bird feeders out of them. bob.
Maybe that's because it is supposed to run on 8 foot minimum curves!
-Brian
that was a typo. i run my k on 16 1/2 foot curves not 6 1/2. what about the johnson bar location? its position can make noise in reverse? if my k is running light it does not make a noise in reverse. i think the skweel in curves is flange skweel? when i run it with cars i only run 6 cars ,caboose ,and 1 aml j&s pas car.a total of 8 cars.
Call or email TOC on the Johnson bar. I know he mentioned this to me before on the K, as I posted earlier. You need to ask him, don't wait for him to pop up here... you could also go to LSC and ask.
Regards, Greg